CLEAN, INSPECT, AND REPAIR - TM-9-2350-261-20-2

R E P A I R L E F T / R I G H T S T E E R I N G L E V E R S

FOLLOW-THROUGH STEPS - TM-9-2350-261-20-2_520

TM-9-2350-261-20-2 Carrier Personnel Full Tracked Armored M113A2 2350-01-068-4077 Carrier Command Post Light Tracked M577A2 2350-01-068-4089 Manual
Page Navigation
483

TM 9-2350-261-20-2 NOTE Both right and left steering levers, in this section are removed and installed the same way. 8. 9. 10. 11. 12. Remove spring pin (1) from plunger (2). Re- move plunger from rod (3). Discard spring pin. Remove two spring pins (4) from rod (3). Discard spring pins. Remove rod (3), three washers (5), and spring (6) from lever arm (7). Remove nut (8), pawl (9), and nut sleeve (10) from rod (3). Remove locknut (11), flat washer (12), washer (13), bolt (14) and rod clip (15) from steering lever (7). Discard locknut. CLEAN, INSPECT, AND REPAIR 13. 14. 15. 16, Check lever arm, button, and spring. Replace cracked or broken parts. Check all threads. Replace parts with stripped threads. Check pawl. Replace nicked or worn pawl. Check bearing, bracket, retaining rings, and quadrants for wear or damage. Replace all damaged parts. I N S T A L L 17. 18. 19. 20. 21. Install rod clip (15) on steering lever (7). Secure with bolt (14), flat washer (12), washer (13) and new locknut (11). Install nut sleeve (10), nut (8) and pawl (9) on rod (3). Install three washers (5), spring (6) on rod (3). Install parts assembled in steps (18 and 19) on steering lever (7). Secure with two new spring pins (4). Install plunger (2) in rod (3). Secure with new spring pin (1). 23-8

Privacy Statement
Press Release
Contact