I N S T A LL - TM-9-2350-261-20-2

FOLLOW-THROUGH STEPS - TM-9-2350-261-20-2_524

TM-9-2350-261-20-2 Carrier Personnel Full Tracked Armored M113A2 2350-01-068-4077 Carrier Command Post Light Tracked M577A2 2350-01-068-4089 Manual
Page Navigation
487

TM 9-2350-261-20-2 I N S T A LL N O T E If arm bearing (1) is to be replaced, use shim (2) as a template to locate and drill two .250-.252 inch (6mm) holes in base of new bearing before installation. If there is no shim, make template from old bearing. 11. 12. Assemble cross-shafts (3 and 4), arm bear- ing (1), lube fittings (5), and two thrust washers (6) as a unit. Install through power plant compartment bulkhead opening. Place shim (2) and bearing (1) on bracket (7). Secure with two new tapered pins (8), new locknuts (9), washers (10), and screws (11). 13. 14. 15. 16. Install two clevises (12) on cross-shafts (3 and 4). Secure with two clevis pins (13, washers (14) and new cotter pins (16). Install new gasket (16) and covers (17 and 18) on five press nuts (19) in power plant compartment bulkhead. Secure with five new locknuts (20), screws (21), and wash- ers (22). Install bearing (23) in bracket (24). Secure with two retaining rings (25). Use snap ring pliers. Install two quadrants (26) and stops (27) on bracket (24). Secure with two screws (28) and new locknuts (29). 23-12

Privacy Statement
Press Release
Contact