TM 9-2350-261-20-2
R E P L A C E S T E E R I N G L E V E R S C R O S S - S H A F T S A N D B E A R I N G S
D E S C R I P T I O N
This task covers:
Remove (page 23-10).
Install (page 23-12).
I N I T I A L S E T UP
Tools:
References:
General Mechanics Tool Kit (Item 30, App D)
see your -lo
Snap Ring Pliers (Item 45, App D)
See your LO
Materials/Parts:
Equipment Conditions:
Cotter Pin (2)
Gasket
Self-locking nut (2)
Self-locking nut (2)
Self-locking nut (5)
Tapered Pin (2)
Personnel Required:
Unit Mechanic
Engine stopped/shutdown (see your -10)
Carrier blocked (see your -10)
Ramp lowered (see your -10)
Trim vane lowered and power plant front
access door open (see your -10)
Driver’s power plant access panel removed
(page 24-25)
Air cleaner housing and element removed
(page 7-7)
Oil can bracket removed (page 24-237)
Driver’s seat removed (page 24-127)
R E M O V E
1.
2.
3.
4.
Disconnect two return springs (page 23-2).
Remove steering levers, bracket, and shim
(page 23-7).
Remove two screws (1), locknuts (2), stops
(3), and quadrants (4) from bracket
Discard locknuts.
Remove two retaining rings (6) and bearing
(7) from bracket (5).
(5). -
23-10
