TM 9-2350-261-20-2 6.7.8.9.10.11.12.Check gap between pawls (1) and top ofquadrants (2) while moving steering levers(3) from front to back. Use 5/32, 3/16, and7/32 inch (4, 5, and 6 mm) diameter drillbit shanks to check gap. Clearance shouldbe between 5/32 (4 mm) and 7/32 (6 mm).If 5/32 or 3/16 inch (4 and 5 mm) drillswill fit but 7/32 inch (6 mm) drill will not,gap is right. If 7/32 inch (6 mm) drill willfit, it must be snug in gap throughout levertravel for gap to be right.If gap is wrong, do steps 9 through 17while referring to pawl adjustment chart. Ifgap is correct, go to step 18.Loosen front quadrant screw (4) and lock-nut (5) that secure quadrants (2) tobracket (6).Remove rear screw (4) and locknut (5) frombracket (6) and quadrants (2).Remove three washers (7), spring (8), andtwo spring pins (9) from plunger rod (10),remove from steering lever (3). Discardspring pins.Loosen pawl jamnuts (11) to adjust pawl(1) to quadrant clearance.Set clearance between 5/32 inch (4 mm)and 7/32 inch (6 mm). Then tightenjamnuts (11). One complete turn will movepawl (1) 1/32 inch (0.8 mm).PAWL ADJUSTMENT CHARTGO TO NEXT PAGE23-5
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business