5.
6.
7.
Remove two cotter pins (1), clevis pins (2),
8.
and washers (3) that secure two clevises (4)
to cross shafts (5 and 6). Discard cotter pins.
Remove five screws (7), washers (8), and
9.
locknuts (9) that secure covers (10 and 11)
and gasket (12) to five press nuts (13) in
power plant compartment bulkhead. Discard
10.
gasket and locknuts.
Remove two screws (14), washers (15), lock-
nuts (16), tapered pins (17), arm bearing
(18), and shim (19) from bracket (20). Dis-
card tapered pins and locknuts.
TM 9-2350-261-20-2
Remove cross-shafts (5 and 6) and arm
bearing (18) as a unit through power plant
compartment bulkhead.
Separate cross-shafts (5 and 6), arm bear-
ing (18), and two thrust washers (21).
Remove lubrication fittings (22) from arm
bearing (18) and cross-shaft (5).
GO TO NEXT PAGE
23-11
