FOLLOW-THROUGH STEPS - TM-9-2350-261-20-2

CLEAN, INSPECT, AND REPAIR - TM-9-2350-261-20-2_519

R E P L A C E S T E E R I N G L E V E R S C R O S S - S H A F T S A N D B E A R I N G S

TM-9-2350-261-20-2 Carrier Personnel Full Tracked Armored M113A2 2350-01-068-4077 Carrier Command Post Light Tracked M577A2 2350-01-068-4089 Manual
Page Navigation
484

22. 23. 24. Install right steering lever (1) on cross-shaft (2). Secure With new locknut (3), and screw (4). Install bearing (5) in bracket (6) and secure with two retaining rings (7). Use snap ring pliers. Install two quadrants (8), two stop levers (9), on bracket (6) with two screws (10) and new locknuts (11). 25. TM 9-2350-261-20-2 Install bracket (6) on cross-shaft (2). Install shims (12) between bracket (6) and driver’s floor plate. Secure with two washers (13) and screws (14). N O T E The same number of shims removed will be installed. 26. 27. Install left steering lever (15) on cross-shaft (2). Secure with woodruff key (16), new locknut (17), and screw (18). Tighten locknut (17) to 204–240 lb-in (23–27 N·m) torque. FOLLOW-THROUGH STEPS 1. Adjust brake locking pawl (page 23-4). 3. Operate earner (see your -10). Check that steering levers operate properly. 2. Install driver’s seat (page 24-127). END OF TASK 23-9

Privacy Statement
Press Release
Contact