TM 9-2350-261-34
11.
12.
Locate two holes in front of carrier as
shown. Drill two 5/16 inch (8 mm) diameter
holes to 1-5/16 inch (3 cm) maximum
depth.
Use a 3/8-16 unc-2B tap to thread the two
holes to 1-1/8 inch (3 cm) minimum thread
depth.
13.
14.
Locate two holes in front of carrier as
shown. Drill two 5/16 inch (8 mm) diameter
holes to 1-5/16 inch (3 cm) maximum
depth.
Use a 3/8-16 UNC-2B tap to thread two
15.
16.
Locate three holes in driver’s compartment
as shown. Drill three 13/64 inch (5 mm)
diameter holes on inside of forward sloped
hull plate to 1-1/8 inch (3 cm) depth.
Use a 1/4-20 UNC-2B tap to thread these
three holes to 3/4 inch (19 mm) minimum
thread depth.
N O T E
Dimensions are in inches with metric
equivalents.
17. Locate hole in power plant compartment side
panel as shown. Drill a 9/16 inch (14 mm)
diameter hole through panel.
holes to 1-1/8 inch (3 cm) minimum thread
depth.
N O T E
Dimensions are in inches with metric
equivalents.
GO TO NEXT PAGE
21-3
