TM 9-2350-261-34
26.
27.
28.
Install new wiring harness (1). Connect
harness to control (2) and flasher (3).
Install new lead (4) and flasher ground
lead (5) to hull. Secure leads to hull with
new washer (6) and screw (7). Install
terminal retaining washer (8) between hull
and leads.
Install new clamp (9) on bilge pump
discharge tube (10). Secure clamp (9) and
loose end of new lead (4) with new screw
(11), two new washers (12), and nut (13).
29.
30.
31.
32.
Disconnect connector (14) from light selector
switch (15) on instrument panel.
Unscrew
nut (16)
grommet
light selector switch
from connector (14)
(17) down on leads
packing
Slide
Thread circuit 467 lead of new wiring
harness (1) through packing nut (16) and
grommet (17). Solder circuit 467 lead to
pin J of light switch.
Install grommet (17) in packing nut (16).
Connect to light switch (15).
GO TO NEXT PAGE
21-5
