M O D I FY

C H A P T E R 21 M A I N T E N A N C E O F T U R N S I G N A L K I T

TM-9-2350-261-34 Carrier Personnel Full Tracked Armored M113A2 2350-01-068-4077 Carrier Command Post Light Tracked M577A2 2350-01-068-4089 Manual
Page Navigation
434

TM 9-2350-261-34 M O D I FY 5. 6. On left side of carrier, locate two holes as shown. Drill two 13/64 inch (5 mm) diameter holes to 1-1/8 inch (3 cm) maximum depth. Use a 14-20 UNC-2B tap to thread these two holes to 9/16 inch (14 mm) minimum depth. N O T E Reflector may be used as a template. 7. 8. 9. On right side of carrier, use a hand file to file outside sharp edge from right tail light large mounting hole. File to about 1/16 inch (2 mm) radius. Locate two holes as shown. Drill two 13/64 inch (5 mm) diameter holes to 1–1/8 inch (3 cm) maximum depth. Use a 1/4-20 UNC-2B tap to thread two holes to 9/16 inch (14 mm) minimum depth. 21-2 N O TE Dimensions are in inches with metric equivalents. N O T E With guard installed on carrier, notch is located in lower flange. 10. Modify left stop light–tail light guard. Lay out and cut a 2–1/2 inch (6 cm) wide notch to full depth of guard flange as shown.

Privacy Statement
Press Release
Contact