TM 9-2350-261-34
10. If pintle socket plate mounting holes are not
12. Drill all holes to 1–1/4 inch (3 cm)
drilled and tapped in cargo cover and on
maximum depth. Tap all holes to 7/8 inch
inside rear hull plate, go to step 11. If these
(22 mm) minimum depth.
holes have been drilled and tapped, go to
step 13.
13. Remove two 1/2 inch (13 mm) screws and
four washers from cargo cover. Remove two
11. Measure center point for four holes as
screws and four washers from inside rear
shown below. Two holes are on cargo cover.
hull plate. Discard washers. Keep screws.
Two holes are on inside rear hull plate.
GO TO NEXT PAGE
20-7
