INSTALL - TM-9-2350-261-34

TM-9-2350-261-34 Carrier Personnel Full Tracked Armored M113A2 2350-01-068-4077 Carrier Command Post Light Tracked M577A2 2350-01-068-4089 Manual
Page Navigation
436

TM 9-2350-261-34 18. Clean areas around all drilled holes with wire brush. Apply TM 43-0139. INSTALL 19. Remove screw (1) secure instrument 20. Remove screw (4), paint, as needed. See and washer (2) that panel to upper mount nut (5), mounts (6 and 7), and washer (8). a (3). 21. Swing instrument panel out to provide access to light selector switch (9) and connector (10). 22. 23. 24. Place new flasher (11) on inside front sloped hull plate. Secure with two new washers (12) and screws (13). Use a scraper to remove paint from front bilge pump^-discharge tube (14). This provides a ground for control assembly and clamp ( 16). Install new control (15) on discharge (15) tube (14). Place control 1/2 inch (13 mm) maximum below sight glass. N O T E The control lever, when placed in RIGHT SIGNAL POSITION, wil be 6 inches (15 cm) from inside front sloped hull plate. 25. Tighten control assembly (15) and clamp ( 16). 21-4

Privacy Statement
Press Release
Contact