T M
70.
71.
9-2350-261-34
Install coolant heater fuel pump lead (1) on
hull mount. Secure with two Iockwashers
(2), screw (3), and nut (4).
Install coolant heater fuel pump (5) on hull
bracket. Secure with four Iockwashers (6)
and two screws (7).
W A R N I N G
Dry
cleaning
solvent
(P-D-680) is TOXIC and
flammable. Wear protective
goggles and gloves; use only
in
well-ventilated area;
avoid contact with skin,
eyes, and clothes, and do not breathe
vapors. Keep away from heat or flame.
Never smoke when using solvent; the
flashpoint for type I dry cleaning solvent
is 100°F (38°C) and for type II is 138°F
(50°C). Failure to do so may result in
injury or death to personnel.
72.
73.
74.
75.
76.
77.
78.
79.
80.
Clean external pipe threads
with dry cleaning solvent.
of fuel pump (5)
Apply a thin, even coat of primer and then
sealing compound (Item 70) to cleaned exter-
nal pipe threads of fuel pump (5). Do not
apply primer or sealing compound beyond
small end of threads.
Remove cap (8) from tee (9). Discard cap.
Install fuel hose (10) on tee (9). Secure with
sleeve (11) and nut (12).
Install adapter body (13) on coolant heater
fuel pump (5).
Secure fuel hose (10) to adapter body (13)
with sleeve (14) and nut (15).
Install elbow body (16) on coolant heater
fuel pump (5).
Install fuel hose (17) on elbow body (16).
Secure with sleeve (18) and nut (19).
Connect circuit 402A lead (20) to coolant
heater fuel pump lead (1).
14-42
