TM 9-2350-261-34
goggles and
W A R N I NG
Dry
cleaning
solvent
P - D - 6 8 0 is
toxic
and
flammable. Always use in
an open area with good air
flow, away from sparks,
h e a t , o r f l a m e s . W e ar
gloves.
Do not breathe
vapors. Avoid contact with skin, eyes, and
clothes. If you get dizzy while using
solvent, breathe fresh air and get medical
help. If solvent gets on hands, wash them.
If solvent gets in eyes, flush eyes with
fresh water and get medical help
immediately.
Keep fire extinguisher
nearby.
49.
50.
Clean external pipe threads of elbow (1) and
draincock (2) with dry cleaning solvent.
Apply a thin, even coat of primer and then
sealing compound (Item 70) to cleaned exter-
nal pipe threads of elbow (1) and draincock
(2). Do not apply primer or sealing
compound beyond small end of threads.
51.
52.
53.
54.
55.
56.
57.
58.
Remove two screws (3), washers (4), plate
(5), and gasket (6) from engine right side.
Discard plate and gasket. Retain screws and
washers.
Install elbow (1) and draincock (2) in
mount (7).
Apply a thin coat of sealing compound
(Item 71) to both sides of gasket (8) before
assembly.
Install mount (7) and gasket (8) over engine
right side opening. Secure with two screws
(3) and washers (4).
Install hose (9) on elbow (1). Secure with
clamp (10).
Install insulation tube (11) on hose (9). Se-
cure with tape.
Install hose (9) on shutoff cock (12). Secure
with clamp ( 13).
Install hose (9) on two weldnuts (14). Se-
cure with two screws (15) and clamps (16).
GO TO NEXT PAGE
14-23