INSTALL (cont) - TM-9-2350-261-34

TM-9-2350-261-34 Carrier Personnel Full Tracked Armored M113A2 2350-01-068-4077 Carrier Command Post Light Tracked M577A2 2350-01-068-4089 Manual
Page Navigation
357

19. 20. 21. 22. 23. 24. 25. 26. Remove four screws (1), washers (2), and plate (3) from power plant compartment wall. Discard plate. Install exhaust pipe (4) on lower elbow (5) and upper elbow (6). Secure with two clamps (7). Do not tighten clamps. Install lower elbow (5) on coolant heater (8). Secure with clamp (7). Do not tighten clamp. Install upper elbow (6) and gasket (9) on power plant compartment wall opening. Secure with four screws (1) and washers (2). Tighten three clamps (7). Raise and secure map table (10). Remove three wing nuts (11) and battery box cover (12) from battery box (13). Remove batteries from battery box (13) (see your –20). Clean battery box and bat- tery box cover (12) (see TM 9-6140-200-14). goggles and W A R N I N G Dry cleaning solvent P - D - 6 8 0 is toxic and flammable. Always use in an open area with good air flow, away from sparks, h e a t , o r f l a m e s . Wear gloves. Do not breathe vapors. Avoid contact with skin, eyes, and clothes. If you get dizzy while using solvent, breathe fresh air and get medical help. If solvent gets on hands, wash them. If solvent gets in eyes, flush eyes with fresh water and get medical help immediately. Keep fire extinguisher nearby. 27. Clean battery box (13) and battery box cover (12) with dry cleaning solvent. W A R N I N G Vapors from methyl isobu- tyl ketone are harmful. Use only with good ventilation. Avoid prolonged breathing of vapors and contact with skin. 28. Renew adhesive backing on all insulation isobutyl ketone. Wait 10 adhesive becomes tacky. 14-20 TM 9-2350-261-34

Privacy Statement
Press Release
Contact