TM 9-2350-261-34
29.
30.
31.
32.
33.
34.
Install bottom insulation sheet (1), left insu- 35.
lation sheet (2), right insulation sheet (3),
rear insulation sheet (4), and front insula-
tion sheet (5) in battery box (6).
36.
Install insulation sheet (7) on battery box
cover (8).
37.
Install two grommets (9) in battery box (6).
Place two clamps (10) on heat
exchanger (11).
Install heat exchanger (11) in battery
box (6).
Install two short hoses (12) on heat
exchanger (11). Secure with two
clamps (10).
38.
39.
40.
Install two elbows (13) in two short hoses
(12). Secure with two clamps (14).
Remove and discard two blank grommets
from power plant bulkhead.
Install two grommets (15) in power plant
compartment bulkhead.
Thread hose (16) and hose (17) through two
grommets (15) in power plant compartment.
Pull two hoses (16 and 17) through two
grommets (15) into personnel compartment
to battery box (6).
Install two insulation tubes (18) on two
hoses (16 and 17) at rear of power plant
compartment. Secure with tape.
GO TO NEXT PAGE
14-21
