R E P L A C E P I V O T S T E E R M A S T E R C Y L I N D E R S A N D H O S ES

CLEAN, INSPECT AND REPLACE - TM-9-2350-261-20-2_578

TM-9-2350-261-20-2 Carrier Personnel Full Tracked Armored M113A2 2350-01-068-4077 Carrier Command Post Light Tracked M577A2 2350-01-068-4089 Manual
Page Navigation
542

TM 9-2350-261-20-2 R E P L A C E P I V O T S T E E R M A S T E R C Y L I N D E R S A N D H O S ES DESCRIPTION This task covers: Remove (page 23-66). Install (page 23-67). INITIAL SETUP Tools: General Mechanics Tool Kit (Item 30, App D) Materials/Parts: FRH hydraulic fluid (Item 19, App C) Cotter pin (2) Preformed packing (2) Self-locking nut (3) Personnel Required: Unit Mechanic References: See your -10 Equipment Conditions: Engine stopped/shutdown (see your -10) Carrier blocked (see your -10) Ramp lowered (see your -10) Driver’s seat removed (page 24-127) Pivot steer system drained (page 23-61) REMOVE N O T E Both master cylinders are removed and installed in the same way. 1. Remove hose (1), nut (2), and adapter (3) from elbow (4). 2. Remove elbow (4) and preformed packing (5) from master cylinder (6). Discard packing. 3. Remove cotter pin (7) and clevis pin (8). Disconnect clevis (9) from levers and shaft (10). Discard cotter pin. 4. Remove three screws (11), locknuts (12), and 5. 6. 7. master cylinder (6) from support (13). Discard locknuts. Remove master cylinder filler cap (14). Empty master cylinder (6). Remove clevis (9) and bellows (15) from master cylinder (6). Disconnect hose (1) from bulkhead elbow (16). 23-66

Privacy Statement
Press Release
Contact