10. Install clevis (2) to levers and shaft (7).
Secure with clevis pin (8) and new cotter
pin (9).
INSTALL
8. Install bellows (1) and clevis (2) in master
cylinder (3).
9. Place master cylinder (3) on support (4).
Secure with three screws (5) and new
locknuts (6).
11.
12.
13.
14.
Install new
bow (11) in
TM 9-2350-261-20-2
preformed packing (10) and el-
master cylinder (3).
Secure adapter (12), nut (13), and hose (14)
to elbow (11).
Connect hose (14) to bulkhead elbow (15).
Bleed and fill pivot steer system
(page 23-61). Install master cylinder filler
cap (16).
FOLLOW-THROUGH STEPS
1. Install driver’s seat (page 24-127).
4. Operate carrier to check that brake system
operates properly.
2. Start engine (see your -10). Check for hy-
draulic leaks.
5. Stop/shutdown engine (see your –10).
3. Raise and lock ramp (see your –10).
END OF TASK
23-67
