CLEAN, INSPECT, AND REPLACE
5. Check all parts for cracks, wear, and
damage. Replace if needed.
INSTALL
6.
7.
8.
9.
Install four nuts (1) on rod end bearings (2).
Install four rod end bearings (2) in two
links (3). Do not tighten nuts.
Install two links (3) on bellcranks (4).
Secure with four screws (5) and new
locknuts (6).
Place two handles (7) in four mounts (8).
Secure with two shafts (9) and four new
cotter pins (10).
10.
11.
12.
13.
Install two links
with two screws
TM 9-2350-261-20-2
(3) on handles (7). Secure
(5) and nuts (6).
Attach two springs (11) to handles (7) and
brackets (12).
Adjust pivot steer linkage (page 23-72).
Tighten four nuts (1) that secure rod end
bearings (2) to two links (3).
FOLLOW-THROUGH STEPS
1. Install drivers seat (page 24-127).
3. Adjust pivot steering links (page 23-72).
2. Operate carrier (see your -10). Check that
4. Engine stopped/shutdown (see your -10).
pivot steer system operates properly.
END OF TASK
23-63