CLEAN, INSPECT, AND REPLACE - TM-9-2350-261-20-2

R E P L A C E / R E P A I R P I V O T S T E E R B R A K E S , H O S E S , T U B E S , A N D F I T T I N G S

FOLLOW-THROUGH STEPS - TM-9-2350-261-20-2_583

TM-9-2350-261-20-2 Carrier Personnel Full Tracked Armored M113A2 2350-01-068-4077 Carrier Command Post Light Tracked M577A2 2350-01-068-4089 Manual
Page Navigation
545

TM 9-2350-261-20-2 CLEAN, INSPECT, AND REPLACE 11. Check all parts for cracks, wear, and dama- ge. Replace if needed. INSTALL 12. 13. 14. 15. 16. Install four new packings (1), two elbows (2), and tees (3) in pivot steer brakes (4). Connect two tubes (5) to tees (3) and elbows (2). Connect two tubes (6) to tees (3). Install two eIbows (7) in tubes (6). Install four elbows (8) (with bleeder valves) 19. 20. 21. 22. 23. 24. and four new packings (9) in pivot steer brakes (4). 25. C A U T I O N Do not scratch brake cylinder walls when pushing brake pistons to bottom of cylin- ders 17. 18. Using a suitable tool, push brake pistons (10) into pivot steer brake halves (4) until pistons bottom out. Install one brake lining (11) in each pivot steer brake half (4). 26. Place two brakes (4) on pivot steer disks (12). Secure with six screws (13), washers (14), and two clips (15). Tighten six screws (13) to 100-110 lb-ft (136-149 N-m) torque. Use torque wrench. Connect two hoses (16) and quick disconnect couplings (17) to elbows (7). Install two elbows (18) in bulkhead. Secure with two nuts (19). Connect two tubes (20 and 21) to elbows (18) and hoses (16). Install two tubes (20 and 21) to five weld- nuts (22). Secure with five clamps (23), washers (24), and screws (25). Fill pivot steer system (see your LO). Bleed pivot steer system (page 23-61). GO TO NEXT PAGE 23-69

Privacy Statement
Press Release
Contact