TM 9-2350-261-20-2
CLEAN, INSPECT AND REPLACE
11,
6. Check all parts for cracks, wear and dam-
age. Replace if needed.
12.
INSTALL
7.
8.
9.
10.
Install four rod ends (1) on ends of levers
13.
and shafts (2).
Secure four rod ends (1) to mount (3) with
eight new locknuts (4).
Install mount (3) on two brackets (5).
Secure with six screws (6), washers (7), and
nuts (8).
Install two links (9) to levers and shafts (2)
Secure with two screws (10) and nuts (11).
Install two master cylinders (12) on
mount (3). Secure with six screws (13).
Install two master cylinders (12) to levers
and shafts (2). Secure with two clevis pins
(14) and new cotter pins (15).
Adjust pivot steer linkage (page 23-72).
FOLLOW-THROUGH STEPS
1. Install driver’s seat (page 24-127).
4. Operate carrier (see your -10). Check that
pivot steer system operates properly..
2. Start engine (see your -10).
5. Stop/shutdown engine (see your -10).
3. Raise and lock ramp (see your -10).
END OF TASK
23-65
