TM 9-2350-261-20-2
INSTALL
10.
7.
8.
9.
Place range selector (1) on drivers compart-
ment bulkhead. Secure with three
washers (2) and screws (3).
11.
Install arm (4) on range selector (1). Secure
with new spring pin (5).
Install link (6) on arm (4). Secure with
screw (7) and new locknut (8).
Connect two electrical leads (9 and 10) to
circuits 74 and 74A (all earners except
M741A1).
On M741A1 only, connect three electrical
leads (11, 12, and 13) to circuits 14, 74,
and 641F.
FOLLOW-THROUGH STEPS
1. Install air cleaner element and housing
3.
(page 7-7).
2. Install drivers power plant access panel
4.
(page 24-25).
Close power plant front access door and raise
trim vane (see your 10).
Operate earner to check that transmission
range selector operates properly.
Stop/shutdown engine (see your 10).
5.
END OF TASK
23-49