TM 9-2350-261-20-2
R E P L A C E F U E L S H U T O F F C A B LE
DESCRIPTION
This task covers:
Remove (page 23-44).
Install (page 23-45).
Adjust (page 23-46).
INITIAL SETUP
Tools:
General Mechanics Tool Kit (Item 30, App D)
Materials/Parts:
Cotter pin
Self-locking nut (3)
Personnel Required:
Unit Mechanic
References:
See your -10
Equipment Conditions:
Engine stopped/shutdown (see your -10)
Carrier blocked (see your -10)
Ramp lowered (see your -10)
Trim vane lowered and power plant front
access door open (see your -10)
Power plant rear access panel removed
(page 24-27) or (page 24-29)
1.
2.
3.
Remove locknut (1) and screw (2) from
engine bracket (3). Discard locknut.
Remove locknut (4), screw (5), and clamp
(6) from engine bracket (7). Discard locknut.
Remove locknut (8), screw (9), and clamp
(10) from differential bracket (11). Discard
locknut .
4.
5.
6.
Remove three screws (12), washers (13),
and clamps (14) from three weldnuts (15).
Loosen set screw (16). Remove front collar
(17) from control assembly (18).
Remove cotter pin (19), washer (20), and
pin (21) from fuel control arm (22). Discard
cotter pin.
23-44
Change 1
