REPLACE ROAD WHEEL HUB - TM-9-2350-261-20-2

TM-9-2350-261-20-2 Carrier Personnel Full Tracked Armored M113A2 2350-01-068-4077 Carrier Command Post Light Tracked M577A2 2350-01-068-4089 Manual
Page Navigation
447

TM9-2350-261-20-2 REPLACE ROAD WHEEL HUB D E S C R I P T I O N This task covers: Remove (page 22-9). Clean, Inspect, and Replace (page 22-10). Install (page 22-10). . - I N I T I A L S E T U P Tools: General Mechanics Tool Kit (Item 30, App D) Replacer (Item 56, App D) Ring Spacer (Item 70, App D) Torque Wrench (Item 96, App D) Materials/Parts: Grease (Item 18, App C) Sealing compound (Item 47, App C) Cotter pin Hub cap gasket HuD-to-arm seal Inner bearing (as needed) Inner bearing cup (as needed) Outer bearing (as needed) Outer bearing cup (as needed) Ribbed shoulder bolt (as needed) Personnel Required: Unit Mechanic References: See your -10 See your LO TM 9-214 Equipment Conditions: Carrier on level surface Engine stopped/shutdown (see your -10) Carrier blocked (see your -10) Track shroud and covers removed (page 22-2) Road wheel removed (page 22-7) R E M O V E 1. Remove four screws (1), hub cap (2), and gasket (3) from road wheel hub (4). Discard gasket. 2. Remove cotter pin (5), nut (6), and washer (7) from road wheel support arm (8). Discard cotter pin. Remove outer bearing (9) and hub (4) from 3. road wheel support arm (8). Remove seal (10) and inner bearing (11) from hub (4). Discard seal. 4. Remove grease fitting (12) and relief valve (13) from hub (4). 5. If damaged, remove bolt(s) (14) from hub (4). Discard bolt(s). 6. If damaged, remove bearing cups (15 and 16) from hub (4). Discard cups. GO TO NEXT PAGE

Privacy Statement
Press Release
Contact