TM 9-2350-261-20-2
I N S T A L L
9.
10.
Lift track assembly with bar. Place two
road wheels (1) on road wheel arm (2).
Secure loosely with eight washers (3) and
new locknuts (4).
Remove blocks used to keep earner from
your -10).
moving (see
W A R N I N G
You can be hurt if road
wheel lifter slips while road
arm is being lowered. Stand
clear.
12. Block carrier (see your -10).
13. Tighten eight locknuts (4) to 150-170 lb-ft
(203-230 N•m) torque. Use torque wrench.
W A R N I N G
Failure to lock steering lat-
erals and block the road
wheels can allow the carri-
er to move and could result
in injury or death. Always
lock steering laterals and
block road wheels before working on the
earner.
F O L L O W - T H R O U G H S T E P S
1. Adjust track tension (see your -10).
3. Road test earner (page 2-45) to check that
road wheel is installed properly.
2. Install track shroud and covers (page 22-2).
END OF TASK
22-8
