R E P L A C E T R A C K
D E S C R I P T I O N
This task covers:
Remove (page 22-4).
Clean, Inspect, And Replace. (page 22-5)
Install (page 22-5).
I N I T I A L S E T UP
Tools:
References:
General Mechanics Tool Kit (Item 30, App D)
see your -lo
Track Fixture (2) (Item 26, App D)
Track and Sprocket Gage (Item 29, App D)
Equipment Conditions:
Drive Pin Punch (Item 50, App D)
Engine stopped/shutdown (see your -10)
Torque Wrench (Item 96, App D)
Carrier blocked (see your -10)
Personnel Required:
Track shroud and covers removed (page 22-2)
Unit Mechanic
Helper (H)
R E M O V E
1.
2.
3.
4.
5,
Relieve tension and break track
(see your -10).
Remove blocks used to keep carrier from
moving (see your –10).
Start engine (see your -10). Place range
selector in R position. Slowly back carrier
(see your -10).
(H) Guide track (1) over drive sprockets (2),
road wheels (3), and idler wheel (4).
After carrier clears track (1), lock steering
lever (see your -10). Place range selector in
N position. Stop engine (see your -10).
W A R N I N G
Failure to lock steering lat-
erals and block the road
wheels can allow the carri-
er to move and could result
in injury or death. Always
lock steering laterals and
block road wheels before working on the
earner.
6, Block earner (see your -10).
22-4
T M 9 - 2 3 5 0 - 2 6 1 - 2 0 - 2
