install - TM-9-2350-261-20-2

R E P L A C E R O A D W H E E L S U P P O R T A R M , B E A R I N G S , A N D S E A L S

TM-9-2350-261-20-2 Carrier Personnel Full Tracked Armored M113A2 2350-01-068-4077 Carrier Command Post Light Tracked M577A2 2350-01-068-4089 Manual
Page Navigation
449

TM9-2350-261-20-2 15. 16. 17. 18. 19. 20. Place hub (1) on road wheel support arm (2). Completely pack cavity in hub with grease. Pack outer bearing (3) with grease. Install in hub (1). Install washer (4) and nut (5) on support arm (2). Tighten nut to adjust bearing as follows: a. Tighten nut (5) to 140-150 lb-ft (190-203 N•m) torque. Use torque wrench. b. Back off nut (5) until there is no torque. c. Tighten nut (5) to 70-75 lb-ft (95-102 N•m) torque. Use torque wrench. d. Back off nut to align nearest cotter pin hole in nut with cotter pin hole in sup- port arm (2). Install new cotter pin (6) in support arm (2). Install new gasket (7), hub cap (8), and four screws (9) in hub (1). Fill hub (1) with grease (see your LO). F O L L O W - T H R O U G H S T E P S 1. Install road wheel (page 22-7). 3. Road test carrier (page 2-45) to check that hub is installed properly. 2. Install track shroud and covers (page 22-2). 4. Check track tension (see your –10). END OF TASK 22-11

Privacy Statement
Press Release
Contact