FOLLOW-THROUGH STEPS - TM-9-2350-261-20-2

CLEAN, INSPECT AND REPLACE - TM-9-2350-261-20-2_396

TM-9-2350-261-20-2 Carrier Personnel Full Tracked Armored M113A2 2350-01-068-4077 Carrier Command Post Light Tracked M577A2 2350-01-068-4089 Manual
Page Navigation
365

TM 9-2350-261-20-2 19. Install bracket (1) on weldnuts. Secure with two new key washers (2) and screws (3). 20. On M106A2, M125A2, and M1064 place strainer (4) on pump (5). Secure with washer (6) and screw (7). 21. Connect circuit 451 lead (8) to bilge pump (5). FOLLOW-THROUGH STEPS 1. Connect battery ground lead (page 13-2). 4. Turn rear bilge pump switch off (see your –10). 2. Turn MASTER SWITCH ON (see your –10). 5. Raise and lock ramp (see your –10). 3. Turn rear bilge pump switch on (see your -10) and check pump. Put your 6. Stop/shutdown engine (see your -10). hand over pump outlet. You should feel air coming out. This means pump is working. 7. Install rear floor plates (page 24-40). END OF TASK 16-10 Change 2

Privacy Statement
Press Release
Contact