CLEAN, INSPECT AND REPLACE
TM 9-2350-261-20-2
INSTALL
W A R N I NG
Dry
cleaning
solvent
P - D - 6 8 0 i s
toxic
and
flammable. Wear protective
goggles and gloves; use only
in well-ventilated area;
avoid contact with skin,
eyes, and clothes, and do not breathe
vapors. Keep away from heat or flame.
Never smoke when using slovent; the
flash point for type I dry cleaning solvent
is 100° F (38°C) and for type II is 138° F
(50°C). Failure to do so may result in
injury or death to personnel.
9.
10.
11.
Clean pump and strainers with dry cleaning
solvent.
Check cushion (1). Replace cushion that
shows loss of resiliency.
Check bracket (2) for damage. Replace as
needed.
12.
13.
14.
15.
16.
17.
18.
On M106A2, M125A2, and M1064 only,
place bracket (2) on pump (3). Secure with
screw (4) and new locknut (5).
Install adapter (6) in pump (3). Use
adjustable wrench. Place ground lead (7) on
pump. Secure with two new lockwashers (8)
and screw (9).
Secure cushion (1) to pump (3) with adhe-
sive.
Install pump (3) in carrier. Slide hose (10)
on adapter (6) and secure with clamp (11).
Place strainer (12) (M106A2, M125A2, and
M1064 only) or strainer (13) (all other carri-
ers) on hull weldnuts.
Install bracket (14) on weldnuts.
Secure with three new lockwashers (15),
ground lead (7), new key washer (16), and
two screws ( 17).
GO TO NEXT PAGE
Change 2
16-9
