TM 9-2350-261-20-2REPAIR CABLE ASSEMBLY DESCRIPTIONThis task covers:Remove (page 14-9).Install (page 14-10).INITIAL SETUP Tools:General Mechanics Tool Kit (Item 30, App D)Soldering Gun (Item 34, App D)Digital Multimeter (Item 43, App D)Electrical Tool Kit (Item 75, App D)Materials/Parts:Insulation sleeving (Item 21 thru 25, App C)Solder (Item 57, App C)Personnel Required: Unit MechanicReferences:see your -10see your -24PEquipment Conditions: Engine stopped/shutdown (see your –10)Battery ground lead disconnected (page 13-2)Carrier blocked (see your -10)REMOVE1.2.3.4.5.N O T EUse same procedure for repairing singleor multiple lead, and male or femalereceptacle.Loosen retaining nut (1) from plugnut back on cable (3).Remove grommet (4) with contactsrear of plug (2).(2). Slide(5) fromRemove plug (2) and coupling nut (6) fromcable (3).Push leads of cable (3) into grommet (4) untilcontacts (5) are fully exposed on other side ofgrommet. Clip or desolder leads fromcontacts. Use soldering gun. Discard contacts.Remove grommet (4) and retaining nut (1)from cable (3).CLEAN, INSPECT, AND REPAIR6.7.8.Check wire leads. Look for damaged insula-tion or broken wires. If wire leads have been taped together, remove tape. Scrape wire leadcovering with your thumbnail to see ifcovering peels off. Replace bad leads.Check contact pins, contact sockets, andterminals. Replace burned, bent, or brokenparts.Check shells, sleeves, and nipples. Replacecut, torn, or damaged parts.GO TO NEXT PAGE14-9
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
