TM 9-2350-261-20-2 b. If lead (1) has insulated sleeving (2), cut5. Remove multiple connectors the same way asand discard sleeving from lead.single connectors. Be sure to tag leads to en-sure correct installation. See steps 1 and 2above.c. If lead (3) isvise (4). Cutterminal (5).of large diameter, place inlead as close as possible toUse hacksaw frame andblade. Discard terminal.6.N O T EFor wiring harness repair,essary to remove Y-typedummy plugs.it may be nec-adapters andRemove Y-type adapter or dummy plug fromharness lead,a. Pull harness leads (8) from Y-typeadapter (9). Remove adapter.d. If lead (6) is of small diameter, cut leadas close as possible to terminal (7). Dis-card terminal.N O TEUnit Maintenance can only repair multi-pin plugs with up to three sockets. Forplugs with more than three sockets, notiyyour supervisor. b. Pull dummy plug (10) from male or fe-male connector (11).14-4
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business