TM 9-2350-261-20-2INSTALLN O TEIf replacing lead, cut new wire from bulksupply. Measure original length, gage,and type of wire.7. Install male connector on harness lead.a. Strip insulation from lead (1) to uncoverjust enough wire to fill contact pin well.b. Slide shell (2) and washer (3), if removed,over lead (1).C A U T I ONCrimping lower part of pin may damagepin and it will not hold lead. Crimp onlymiddle part of contact pin with correctsize die.c.d.Insert lead (1) into new pin (4) andcrimp.If removed, place slotted washer (5) onlead (1) under pin (4) and pull shell (2)over washer (3 or 5) and pin.8. Install female connector on harness lead.a. Strip insulation from lead (6) to uncoverjust enough wire to fill contact socketwell.b. Slide shell (7) and sleeve (8) over lead (6).c. Insert lead (6) in new socket (9) andcrimp or solder.d, Slide sleeve (8) and shell (7) oversocket (9).9. Install terminal connector on harness lead,a.b.If nipple (10) was removed from lead (11),strip insulation from lead to uncover justenough wire to fill terminal well. Slidenipple over lead.If insulated sleeving (12) was removedfrom lead (13), slide new insulatedsleeving on lead. Strip insulation from leadto same length as crimp (14) onterminal (15).GO TO NEXT PAGE14-5
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business