INSTALL (cont) - TM-9-2350-261-20-2

REPLACE DISTRIBUTION BOX ASSEMBLY FOR 200 AMP GENERATOR SYSTEM (M741A1 ONLY)

TM-9-2350-261-20-2 Carrier Personnel Full Tracked Armored M113A2 2350-01-068-4077 Carrier Command Post Light Tracked M577A2 2350-01-068-4089 Manual
Page Navigation
164

TM 9-2350-261-20-2 23. Install two new grommets (1 and 2), cable assembly W8 lead (3), and circuit 49 lead (4) in distribution box (5). Install circuit 49 lead (4) and cable assembly W8 lead (3) on bus bar (6). Secure with new lockwasher (7) and screw (8). 24. Install new grommet (9) and circuit 10, 14, 15, 27E lead (10) in distribution box (5). Install circuit 10, 14, 15, 27E lead (10) and circuit 450A lead (11) on bus bar (6). Se- cure with new lockwasher (12) and screw (13). 25. Install new grommet (14) and circuit 6 lead (15) in distribution box (5). Install circuit 6 lead (15) and cable assembly W8 leads (3) on bus bar (6). Secure with new lockwasher (16) and screw (17). 26. Apply one coat of adhesive to cleaned mounting surface of distribution box (5) and one side of new gasket (18). 27. Install new gasket (18) on coated mounting surface of distribution box (5). FOLLOW-THROUGH STEPS 1. Install master switch panel (page 9-16). 3. Start engine (see your -10). Check that distribution box operates properly. 2. Connect battery ground lead (page 13-2). 4. Shutdown engine (see your -10). END OF TASK 1 2 - 35

Privacy Statement
Press Release
Contact