TM 9-2350-261-20-2
REPLACE DISTRIBUTION BOX ASSEMBLY FOR 100 AMP
GENERATOR SYSTEM (M901A1 ONLY)
DESCRIPTION
This task covers:
Remove (page 12-32).
Install (page 12-34).
INITIAL SETUP
Tools:
References:
General Mechanics
Materials/Parts:
Sealing compound
Gasket
Grommet (8)
Lockwasher (5)
Lockwasher (5)
Tool Kit (Item 30, App D)
see your -lo
Equipment Conditions:
Item 52, App C)
Engine shutdown (see your -10)
Carrier blocked (see your -10)
Battery ground lead disconnected (page 13-2)
Master switch panel assembly removed
(page 9-16)
Personnel Require:
Unit Mechanic
REMOVE
1.
2.
Remove screw (1), lockwasher (2], circuit 6
lead (3), and cable assembly W8 leads (4 and
5) from bus bar (6). Remove circuit 6 lead
(3) and grommet (7) from distribution box
(8). Discard grommet and lockwasher.
Remove screw (9), lockwasher (10), circuit 10,
14, 15, 27E lead (11), and circuit 450A lead
(12) from bus bar (6). Remove circuit 10, 14,
15, 27E lead (11) and grommet (13) from
distribution box (8). Discard grommet and
lockwasher.
3. Remove screw (14), lockwasher (15), circuit
49 lead (16), and cable assembly W8 leads
(17 and 18) from bus bar (6). Remove circuit
49 lead (16), cable assembly W8 lead (19),
and two grommets (20 and 21) from
distribution box (8). Discard grommets and
lockwasher.
12-32
