ADJUST - TM-9-2350-261-20-2

A D J U S T V O L T A G E R E G U L A T O R ( 1 0 0 / 2 0 0 A M P G E N E R A T O R)

R E P L A C E R E G U L A T O R A S S E M B L Y ( 1 0 0 / 2 0 0 A M P G E N E R A T O R )

TM-9-2350-261-20-2 Carrier Personnel Full Tracked Armored M113A2 2350-01-068-4077 Carrier Command Post Light Tracked M577A2 2350-01-068-4089 Manual
Page Navigation
85

TM 9-2350-261-20-2 CAUTION Battery can get overcharged and explode if the charging volts exceed 29. Adjust voltage regulator to 29 volts. N O T E Do not force adjusting screw past stop. If regulator cannot be adjusted, replace bad regulator. Use insulated cross-tip screw driver #1 to A. Vap-Air Model adjust voltage. 26440001-03 (plug removed) I 90° and above: 27 V 50° thru 89°: 28 V 49° and below: 29 V 7. 8. 9. I With engine operating at 900 to 1100 rpm, turn adjusting screw (1) in regulator (2) until proper voltage reading is achieved. Install receptacle cap (3). Install access screw (4) on regulator (2). B. Vap-Air Model 26440001-04 (cover removed) C. Leece-Neville Model 5027RC (plug removed) D. Leland Model 07639-CSV-2183-1 (cover removed) E. Prestolite Model REG-4000 (plug removed) F. C. E. Niehoff Model N3019 (plug removed) FOLLOW-THROUGH STEPS 1. Stop/shutdown engine (see your -10). END OF TASK Change 1 9-39

Privacy Statement
Press Release
Contact