R E P L A C E R E G U L A T O R A S S E M B L Y ( 1 0 0 / 2 0 0 A M P G E N E R A T O R )

TM-9-2350-261-20-2 Carrier Personnel Full Tracked Armored M113A2 2350-01-068-4077 Carrier Command Post Light Tracked M577A2 2350-01-068-4089 Manual
Page Navigation
86

TM 9-2350-261-20-2 R E P L A C E R E G U L A T O R A S S E M B L Y ( 1 0 0 / 2 0 0 A M P G E N E R A T O R ) D E S C R I P T I O N This task covers: Remove (page 9-40). Clean, Inspect, and Repair (page 9-40). Install (page 9-41). INITIAL SETUP Tools: References: General Mechanics Tool Kit (Item 30, App D) See your -10 Materials/Parts: Equipment Conditions: Lockwasher (8) Engine stopped/shutdown (see your -10) Lockwasher (8) Lockwasher (1) Carrier blocked (see your -10) Battery ground lead disconnected (page 13-2) Personnel Required: Unit Mechanic 63T10 R E M O V E CLEAN, INSPECT, AND REPAIR 1. Disconnect two cannon plugs (1 and 2) from 5. Check cables. Replace worn or cracked cables regulator (3). and damaged connectors (page 14-1). NOTE Ground lead is on 200 amp only. 2. Remove four screws (4), eight lockwashers (5), end of ground lead (6), and mount plate (7) with attached regulator (3) from hull weldnuts. Discard lockwashers. 3. Remove four screws (8), eight lockwashers (9), and mount plate (7) from regulator (3). Discard lo&washers. 4. Remove nut (10), lockwasher (11), and other end of ground lead (6) from ground stud (12) of regulator (3). Discard lockwasher. 9 - 4 0 Change 4

Privacy Statement
Press Release
Contact