TM 9-2350-261-20-2
INSTALL
NOTE
Ground lead is on 200 amp only.
6.
Place regulator (1) upside down and place
four new lock washers (2) on holes (3). Set
7.
mount plate (1) on regulator and place four
new lock washers (5) on holes (6). Secure
mount plate to regulator with four
screws (7).
8.
9.
Set regulator and mount plate assembly (8)
on hull weldnuts (9). Slide from new lock
washers (10) under mount plate (4) on hull
weldnuts. Place four new lock washers (11)
on mount plate over holes (12). Slide end of
ground lead (13) under washer (11). Secure
with four screws (14).
Place other end of ground lead (13) on
ground stud (15). Secure with washer (16)
and nut (17).
Connect two cannon plugs (18 and 19) to
regulator (1).
FOLLOW-THROUGH STEPS
1.
Connect battery ground lead (page 13-2).
2.
Adjust regulator voltage (page 9-38).
END OF TASK
Change 1
9-41
