TM 9-2350-261-20-1
REPLACE VENT HOSES, TUBES, AND FITTINGS
(M577A2 AND M1068 ONLY)
DESCRIPTION
This task covers: Remove (page 6-70).
Install (page (6-71).
INITIAL SETUP
Tools:
General Mechanics Tool Kit (Item 30, App D)
Materials/Parts:
Sealing compound (Item 46, App C)
Lockwasher (12)
Lockwasher (5)
Suitable container
Personnel Required:
Unit Mechanic
References:
See your -10
Equipment Conditions:
Battery ground lead disconnected
13-2)
Engine stopped and ramp lowered
(page
(see your -10)
Map board removed (see your -10)
Work tables removed (page 24-178)
Carrier blocked (see your -10)
REMOVE
1. Drain fuel tanks below level of vent hoses
(page 6-50).
5. Remove seven screws (6), lockwashers (7),
clamps (8), and vent hoses (1 and 3) from
seven weldnuts (9). Discard lockwashers.
2. Disconnect vent hose (1) from elbow (2).
3. Disconnect vent hose (3) from elbow (4).
4. Disconnect vent hoses (1 and 3) from two
elbows (5).
6. Remove five screws (10), lockwashers (11),
clamps (12), and vent hoses (1 and 3) from
five weldnuts (13). Discard lockwashers.
7. Remove three elbows (2, 4, and 14) and
nipple (15) from left fuel tank (16).
6-70
Change 3