TM 9-2350-261-20-1
28. Install elbow (1) in filler neck (2).
29. Connect return tube (3) to elbow (1).
30. Connect return tube (3) to nipple (4) or
tee (4.1) (M1068).
31. Install return tube (3) on four weldnuts (5).
Secure with four clamps (6), new
lockwashers (7), and screws (8).
FOLLOW-THROUGH STEPS
1. Install muffler (page 7-20).
6. Start engine (see your -10). Check return
hoses for leaks.
2. Install personnel heater page 29-51).
3. Install generator (page 9-31 and 9-34).
4. Install electronic equipment heater
(page 31-16).
7. Install map board (see your -10).
8. Install power plant rear access panel
(page 24-29).
5. Connect battery ground lead (page 13-2).
9. Raise and lock ramp (see your -10).
10. Engine stopped/shutdown (see your -10).
END OF TASK
Change 4
6-69
