TM 9-2350-287-20-1
7-18.
NBC POWER CONTROL BOX REPAIR.
This Task Covers:
a.
Removal
b.
Disassembly
c.
Inspection
d.
Assembly
e.
Installation
Initial Setup:
Tools/Test Equipment:
Electrical connector repair tool kit
Lockwasher (2) (Item 148, Appendix H)
(Item 16, Appendix I)
Lockwasher (4) (Item 153, Appendix H)
General mechanic's tool kit (Item 24,
Lockwasher (16) (Item 161, Appendix H)
Appendix I)
Lockwasher (2) (Item 184, Appendix H)
Solder Iron (Item 64, Appendix I)
Equipment Conditions:
Materials/Parts:
Vehicle parked on level ground (refer to
Enamel, insulating (Item 29, Appendix D)
TM 9-2350-287-10).
Solder (Item 66, Appendix D)
Upper and lower rear doors opened (refer to
Gasket (Item 49, Appendix H)
TM 9-2350-287-10).
Gasket (Item 50, Appendix H)
Master switch set to OFF (refer to
Lockwasher (4) (Item 121, Appendix H)
TM 9-2350-287-10).
Lockwasher (4) (Item 134, Appendix H)
Battery ground cables disconnected
Lockwasher (2) (Item 135, Appendix H)
(para 7-41).
Lockwasher (4) (Item 136, Appendix H)
a.
REMOVAL
1.
Disconnect power input harness (3) and NBC harness (1) from NBC power control box (2).
2.
Remove four screws (4) and lockwashers (5) and control box (2) from vehicle. Discard lockwashers.
Change 1 7-50
