7-17. CONVEYOR CONTROL SWITCH REPLACEMENT.

FOLLOW-ON MAINTENANCE - TM-9-2350-287-20-1_745

FOLLOW-ON MAINTENANCE - TM-9-2350-287-20-1_747

TM-9-2350-287-20-1 Carrier Ammunition Tracked M992A21 (2350-01-352-3021) EIC:AE6 Manual
Page Navigation
718

TM 9-2350-287-20-1 7-17. CONVEYOR CONTROL SWITCH REPLACEMENT. This Task Covers: a. Removal b. Installation Initial Setup: Tools/Test Equipment: Equipment Conditions: l General mechanic’s tool kit (Item 24, l Vehicle parked on level ground (refer to Appendix I) TM 9-2350-287-10). l MASTER switch set to OFF (refer to Materials/Parts: TM 9-2350-287-10). l Lockwasher (2) (Item 160, Appendix H) l Battery ground cables disconnected (para 7-41). a. 1. 2. 3. 4. b. 1. 2. 3. 4. REMOVAL Turn four retaining studs (4) on gage panel cover (9). Pull gage panel cover (9) away from gage panel (5). Disconnect electrical connector AAA (6), electrical connector 10 (7), and electrical connector AAB (8) from conveyor control switch (10). Remove two screws (2) and Iockwashers (1 ), switch (10), and guard (3) from gage panel cover (9). Discard Iockwashers. INSTALLATION Install guard (3) and switch (10) on gage panel cover (9) with two new Iockwashers (1 ) and screws (2). Connect electrical connector AAB (8), electrical connector 10 (7), and electrical connector AAA (6) to conveyor control switch (10). Position gage panel cover (9) on gage panel (5)₀ Secure gage panel cover (9) to gage panel (5) with four retaining studs (4). 7-48

Privacy Statement
Press Release
Contact