TM 9-2350-277-20-5
REPLACE REAR BILGE PUMP AND STRAINER
0635 00
THIS WORK PACKAGE COVERS:
Removal (page 0635 00-1).
Installation (page 0635 00-3).
INITIAL SETUP:
Maintenance Level
Unit
Tools and Special Tools
General Mechanic’s Tool Kit (WP 0926 00, Item 65)
Adjustable Wrench (WP 0926 00, Item 75)
Materials/Parts
Adhesive (WP 0928 00, Item 4)
Locknut (M1064A3 only)
Lockwasher (5)
Tablock washer (3)
Personnel Required
Unit Mechanic
References
See your -10
Equipment Condition
Engine stopped (see your -10)
Carrier blocked (see your -10)
Ramp lowered (see your -10)
Battery ground strap disconnected (WP 0337 00),
(WP 0338 00), or (WP 0339 00)
Smoke generator fog oil tank module removed
(M1059A3 only) (WP 0753 00)
Rear floor plate removed (WP 0539 00)
REMOVAL
1.
Disconnect circuit 451 lead (1) from rear bilge pump (2).
2.
On M1064A3 only, remove screw (3), washer (4), and strainer (5) from pump (2).
3.
Remove two screws (6), tablock washers (7), and bracket (8) from hull weldnuts. Discard washers.
0635 00-1
