TM 9-2350-277-20-5
REPLACE FRONT BILGE VALVE — Continued
0633 00
INSTALLATION
1.
Install valve (4) on hull cross beam.
2.
Secure with three screws (3), six washers (2), and three new locknuts (1).
FOLLOW-THROUGH STEPS
1.
Check for freedom of movement of valve after installation.
2.
Install left front floor plate (WP 0539 00).
3.
Install personnel heater floor duct (WP 0706 00).
4.
Install driver’s rear floor plate (WP 0453 00).
5.
Raise and lock ramp (see your -10).
6.
Turn MASTER SWITCH OFF (see your -10).
END OF TASK
0633 00-2
