TM 9-2350-277-20-4
REPLACE FLOOR PLATES (M1059A3 ONLY)
0542 00
THIS WORK PACKAGE COVERS:
Removal (page 0542 00-1).
Installation (page 0542 00-2).
INITIAL SETUP:
Maintenance Level
Unit
Tools and Special Tools
General Mechanic’s Tool Kit (WP 0926 00, Item 65)
Materials/Parts
Adhesive (WP 0928 00, Item 4)
Personnel Required
Unit Mechanic
References
See your -10
Equipment Condition
Engine stopped (see your -10)
Carrier blocked (see your -10)
Personnel floor heater duct removed (WP 0706 00)
Seats folded in stowed position (see your -10)
Ramp lowered (see your -10)
REMOVAL
1.
Remove 12 screws (1) and lined washers (2) securing floor plates to hull crossmembers.
2.
Remove two screws (3) and washers (4) securing floor plates to hull crossmembers.
3.
Remove two rear floor plates (5) and (6) from hull crossmembers.
4.
Remove two front floor plates (7) and (8) from hull crossmembers.
5.
If necessary, remove two non-metallic seals (9) from hull crossmembers by scraping.
6.
If necessary, remove two rubber strips (10) from hull crossmembers by scraping.
7.
If necessary, remove eight pads (11) from hull crossmembers by scraping.
0542 00-1
