TM 9-2350-277-20-4
REPLACE FLOOR PLATES (M981A3 ONLY) Continued
0541 00
8.
Position bracket (3) in place over holes in floor assembly.
9.
Secure bracket (3) on floor assembly (4) with four washers (2) and screws (1).
10. Insert grommet (8) into cutout portion of floor assembly (6) and press firmly into place.
INSTALLATION
NOTE
Inspect electrical cables. Be sure they are not pinched or damaged. Stow targeting head before
starting the following procedures.
1.
Position floor assemblies (1) or (2) on vehicle structural supports (3).
2.
Position heater duct (4) on floor assemblies (1) and (2) and secure in place with three washers (5) and screws (6).
NOTE
Position the targeting station at 180
azimuth. One of the 13 screws (9) securing floor assemblies
(1) and (2) is accessed through the hole in the platform assembly (18).
3.
Install floor assemblies (1) and (2) using seven washers (7), washers (8), and screws (9).
0541 00-5