REPLACE FLOOR PLATES (M1064A3 ONLY)

TM-9-2350-277-20-4 Carrier Personnel Full Tracked Armored M113A3 2350-01-219-7577 (EIC AE7) Carrier Command Post Light Tracked M577A3 2350-01-369-6085 (EIC AE7) Manual
Page Navigation
465

TM 9-2350-277-20-4 REPLACE FLOOR PLATES (M1064A3 ONLY) 0543 00 THIS WORK PACKAGE COVERS: Removal (page 0543 00-1). Installation (page 0543 00-2). INITIAL SETUP: Maintenance Level Unit Tools and Special Tools General Mechanic’s Tool Kit (WP 0926 00, Item 65) Materials/Parts Adhesive Cushioning pad (2) Cushioning pad Cushioning pad Cushioning pad (3) Cushioning pad Locknut (2) Locknut Non-metallic seal (2) Non-metallic seal Personnel Required Unit Mechanic References See your -10 Equipment Condition Engine stopped (see your -10) Carrier blocked (see your -10) Ramp lowered (see your -10) Personnel heater floor duct removed, if installed. (WP 0706 00) REMOVAL 1. Remove screw (1) and washer (2) from guard (3). 2. Remove screw (4), washer (5), locknut (6), and guard (3) from hull. Discard locknut. 3. Remove eight eyebolts (7), one screw (8), and nine lined washers (9) from right front floor plate (10) and left front floor plate (11). 4. Remove two screws (12), lined washers (13), and rear floor plate (14) from carrier. 5. Remove two locknuts (15), washers (16), screws (17), and guard (18) from rear floor plate (14). Discard locknuts. 6. If necessary, remove two pads (19), three pads (20), and pad (21) from front crossmembers by scraping. 0543 00-1

Privacy Statement
Press Release
Contact