TM 9-2350-277-20-4
REPLACE FLOOR PLATES (M1059A3 ONLY) Continued
0542 00
8.
If necessary, remove two pads (12), four pads (13), and two pads (14)(15) from hull crossmembers by scraping.
INSTALLATION
1.
If pads (1) through (5), rubber strips (6), or seals (7) were removed, apply light coat of adhesive to all crossmember
mating surfaces. Allow surfaces to become sticky. Install pads, rubber strips, and seals on crossmembers and press
surfaces firmly together.
2.
Place two front floor plates (8) and (9) on hull crossmembers.
3.
Place two rear floor plates (10) and (11) on hull crossmembers.
4.
Install two washers (12) and screws (13) on front floor plates (8) and (9).
0542 00-2