Tag all cables before disconnecting them.NOTE11. Disconnect W111, plug P1 (1) from jackJ115 (2) on signal patch panel box (3).12. Disconnect W112, plug P1 (4) from jackJ116 (5) on signal patch panel box (3).13. Disconnect W113, plug P1 (6) from jackJ117 (7) on signal patch panel box (3).14. Disconnect W114, plug P1 (8) from jackJ118 (9) on signal patch panel box (3).15. Remove cablehelper assist.INSTALLassemblies from carrier. Have16.17.Install cable assemblies in carrier. Havehelper assist.Push harness into base (10) of external com-munications box (11). Have helper assist.18. Connect W111, plug P1 (1) to jack J115 (2)on signal patch panel box (3).19. Connect W112, plug P1 (4) to jack J116 (5)on signal patch panel box (3).20.21.22.23.24.25.Connect W113, plug P1 (6) to jack J117 (7)on signal patch panel box (3).Connect W114, plug P1 (8) to jack J118 (9)on signal patch panel box (3).Connect harness to inside of faceplate (12)of external communications box (11).Connect W111, plug P2 (13) to jack5115 (14) on faceplate (12).Connect W112, plug P2 (15) to jackJ116 (16) on faceplate (12).Connect W113, plug P2 (17) to jackJ117 (18) on faceplate (12).TM 9-2350-261-3426. Connect W114, plug P2 (19) to jackJ118 (20) on faceplate (12).27. Install clamp (21) and screw (22).28. Install five clamps (23) and screws (24).29. Install new straps (25) as required.30. Install faceplate (12) on externalcommunications box (11), secure with 14screws (26) and new lockwashers (27).31. Lower and secure cover (28) of externalcommunications box (11).FOLLOW-THROUGH STEPS1. Install external communication box(see your -20)END OF TASKChange 421.1-59
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
