TM 9-2350-261-34
67. Install new turn signal light (1), new
stud (2), and new washer (3) in guard (4).
Secure with new lockwasher (5) and new
nut (6).
NOTE
A minimum of 1-1/2 threads should ex-
tend through nut after installing light in
guard.
68. Install new guard (4) with light assembly
on hull. Secure with two new washers (7)
and new screws (8).
69. Connect circuit 461 lead on harness (9) to
new turn signal light (1).
70.
71.
72.
Install elbow (10) on bottom of ramp.
Thread new trailer light wiring harness (11)
through retained cover (12), receptcal
connector (13), gasket (14), elbow (10), nut
(15), spring (16), connector (17), and ramp.
Tighten nut (15) on elbow (10).
NOTE
Be sure harness is not twisted before it is
secured to ramp.
73.
74.
Install new trailer light wiring harness
ground lead (18) and retained wiring
harness clamp (19). Secure with retained
washers (20) and screw (21).
Install four retained shells (22), one new
shell (22), four retained washers (23), and
one new washer (23) on leads of new trailer
wiring harness (11).
21-10
