TM 9-2350-261-34
122.
123.
Cut auxiliary tank hose (1) and secure to
tee (2) with two clamps (3).
Secure hose (4) to tee (2) with clamp (5).
124.
125.
126.
Replace standard generator belts with kit
belts (see your –20).
Replace standard fan drive belts with kit
belts (see your -20).
Open fuel tank shutoff valve (6).
FOLLOW-THROUGH STEPS
1.
2.
3.
4.
5.
6.
Install personnel heater (see your –20).
7.
Fill carrier cooling system (see your –20).
8.
Connect battery ground lead (see your –20).
Bleed coolant heater fuel line (see your -20).
9.
Start coolant heater (see your -10). Check
that heater operates properly and does not
10.
leak. Turn coolant heater off.
11.
Install rear and right front floor plates
(see your -20).
12.
Install driver’s power plant access panel
(see your –20).
Install power plant rear access panel
(see your –20).
Close power plant front access panel
(see your -20).
Raise trim vane (see your -10).
Raise and lock ramp (see your -10).
Stop/shutdown engine (see your –10).
END OF TASK
14-16
