TM 9-2350-261-34 goggles andW A R N I NGDrycleaningsolventP - D - 6 8 0 i stoxicandflammable. Always use inan open area with good airflow, away from sparks,h e a t , o r f l a m e s . W e argloves.Do not breathevapors. Avoid contact with skin, eyes, andclothes. If you get dizzy while usingsolvent, breathe fresh air and get medicalhelp. If solvent gets on hands, wash them.If solvent gets in eyes, flush eyes withfresh waterand get medical helpimmediately.Keep fire extinguishernearby.62.63.64.65.Remove batteries and retainers from batterybox (see your -20). Clean battery box andbattery box cover (see TM 9-6140-200-14).Clean battery box with dry cleaning solvent.Renew adhesive backing on insulation sheetswith dry cleaning solvent. Wait 10 to 20seconds until adhesive becomes tacky.Install insulation sheets (1, 2, 3, 4, and 5)and strip (6) in battery box (7).66.67.68.69.70.71.72.73.Install insulation sheet (8) on battery boxcover (9).Install two clamps (10) on heatexchanger (11).Install two grommets (12) and heatexchanger (11) in battery box (7).Remove two blank grommets from powerplant compartment. Discard grommets.Install two grommets (13) in power plantcompartment bulkhead.Connect coolant pump hose (14) and enginehose (15) to heat exchanger (11). Hosesmust go through grommets (13).Pull two hoses (14 and 15) through twogrommets (13) in personnel compartmentuntil hoses reach battery box (7).Install two insulation tubes (16) on twohoses (14 and 15) at rear of power plantcompartment.GO TO NEXT PAGE14-9
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
